flat and angle
For indoor and outdoor floor joints with a gap up to 200 mm, with large amount of movements. Suitable for traffic of pedestrians and light trolleys.
Section length of 3 m.
Aluminium side angle sections and stainless steel middle plate.
Floor-to-floor type only. The central plate takes the mortar on which the floor covering in laid. Once the floor covering is laid, the joint is practically invisible; only two stainless steel sections remain exposed. Waterproof membrane as option, with possibility of integrating drainage system to recover the liquid. JDH 6.28 joints can be matched to vertical joints of similar finish and with the same movement range (please enquire).
|GAP UP TO (MM)|
|MOVEMENTS (MM)||+25 / -25||+25 / -25||+25 / -25||+25 / -25|
|VISIBLE WIDTH (MM)|
|TOTAL WIDTH (MM)|
The load capacity is always given for a joint in its initial position. In case of opening movements, the load capacity is strongly reduced and the product will only be suitable for light pedestrian traffic. The indicated load values are based on vehicles with pneumatic wheels with a contact area of 200x200 mm.